The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> convergence issue about postsim
https://designers-guide.org/forum/YaBB.pl?num=1442474405

Message started by hiSkill_11 on Sep 17^th, 2015, 12:20am

Title: convergence issue about postsim
Post by hiSkill_11 on Sep 17^th, 2015, 12:20am

Hi guys,

I encountered an error as following when I performed post simulation of RC oscillator(125MHz). This error is gone when I did pre simualtion without parasitics. I used default settig and APS.

Thanks in advance!