The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> Placing components in microstrip coupled lines
https://designers-guide.org/forum/YaBB.pl?num=1443195438

Message started by claitectm2 on Sep 25^th, 2015, 8:37am

Title: Placing components in microstrip coupled lines
Post by claitectm2 on Sep 25^th, 2015, 8:37am

Hello,

I am designing a RF circuit and I have doubts on how to place components in microstrip coupled lines when separation is very low. I have placed two microstrip curves to separate a litle the components but I don't know if it will work in the PCB, considering that the RF microstrip line ends perpendicular to the "direction" of the signal.

Sorry for my english, I have attached an image to help understand my explanation.

Thanks in advance.

Title: Re: Placing components in microstrip coupled lines
Post by aaron_do on Oct 22^nd, 2015, 6:24am

Why not try and simulate the effect using an EM simulator?

Aaron