The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> db2bisonbl parameters issue https://designers-guide.org/forum/YaBB.pl?num=1443453004 Message started by ic_engr on Sep 28th, 2015, 8:10am |
Title: db2bisonbl parameters issue Post by ic_engr on Sep 28th, 2015, 8:10am Hello, We were designing a structure for diode in High Voltage Process. The NWELL was extended to the HVNWELL Boundaries. The structure when extracted gives a db2bisonbl with areantop and perinint of 0. When these parameters are set to zero, the spectre simulation ends with this error: I0.dpepinblsub: Value of `is' should be greater than zero. Any suggestion to solve this problem? ic_engr |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |