The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> ADE-L spectre simulation can't stop https://designers-guide.org/forum/YaBB.pl?num=1536043684 Message started by xiaoli on Sep 3rd, 2018, 11:48pm |
Title: ADE-L spectre simulation can't stop Post by xiaoli on Sep 3rd, 2018, 11:48pm I use virtuoso6.1.7. Just try a simple testbench tran using spectre. simulation covers very fast 100%, but simulation pauses at writing information into some rawfile. at this time, I can plot any voltage in the circuit, but I can't start a new test due to the above unfinished simulation. |
Title: Re: ADE-L spectre simulation can't stop Post by Andrew Beckett on Sep 4th, 2018, 11:56am I've not seen this. I suggest you contact Cadence support at http://support.cadence.com - might be worth updating to the latest IC617 hotfix version and simulator hotfix version too (probably SPECTRE17.1) just in case it's a known issue that's been resolved in the meantime. Regards, Andrew. |
Title: Re: ADE-L spectre simulation can't stop Post by Geoffrey_Coram on Sep 10th, 2018, 8:12am You could try commenting out (or deleting) the info lines that request the subckt info. I don't use ADE, so I'm not sure where in the menus/dialogs you find the check-box to un-check to avoid this; I use Spectre at the command line so I can edit the netlist directly. You should also check that you're not running out of disk space (though I would think Spectre would tell you if this were the problem). |
Title: Re: ADE-L spectre simulation can't stop Post by Andrew Beckett on Oct 21st, 2018, 11:10am You can turn this off via the Save->All form. However, contacting Cadence customer support is the right thing to do because it indicates a problem that needs to be addressed. Regards. Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |