The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> Question on Channel Length modulation https://designers-guide.org/forum/YaBB.pl?num=1609541346 Message started by Sharath Raju on Jan 1st, 2021, 2:49pm |
Title: Question on Channel Length modulation Post by Sharath Raju on Jan 1st, 2021, 2:49pm Hi, Pls see figure attached for context. I was reviewing Razavi book and had the following question: For a common source stage with resistive load, why is channel length modulation *more* significant for larger values of RD? Thanks, Sharath |
Title: Re: Question on Channel Length modulation Post by polyam on Jan 4th, 2021, 11:28am Hi, Channel length modulation causes a non-zero slope in the IV characteristics of the transistor and the slop is inversely proportional to the output resistance i.e. slope=1/ro (ro=rds). The steeper slope (channel length modulation) you have the less output resistance you will get. Now let's have a look at the gain of the CS. It is Av=gm(RD || ro). What happens now? your ro is becoming smaller (due to channel length modulation) while your RD is large. So, Av=gm(RD || ro) becomes approximately Av=gm ro (for a large enough RD). That actually represents the intrinsic gain of the transistor. Another way to look at that is replacing the RD with an ideal current source (with an infinite output resistance). You will see then ro dominates the equivalent output resistance. |
Title: Re: Question on Channel Length modulation Post by Sharath Raju on Jan 4th, 2021, 11:42am Thanks Polyam. Your explanation is very good. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |