The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> Fully Differential Opamp
https://designers-guide.org/forum/YaBB.pl?num=1069488679

Message started by The_One on Nov 22^nd, 2003, 12:11am

Title: Fully Differential Opamp
Post by The_One on Nov 22^nd, 2003, 12:11am

Hi All,

I have a question regarding the fully differential opamp.

for fully differential opamp, how do we measure the slew rate? in single output opamp, the circuit is configured as voltage follower. Then, how about fully differential output? it has two output pin. what configuration should we use?

Thanks.