The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> [question] Spectre simulation https://designers-guide.org/forum/YaBB.pl?num=1078825062 Message started by sim on Mar 9th, 2004, 1:37am |
Title: [question] Spectre simulation Post by sim on Mar 9th, 2004, 1:37am What's wrong with my simulation? For exmaple: Model----ideal-opamp.scs ideal-opamp.va input command ----- spectre ideal-opamp.scs spectre compeles with 0 errors,0 warnings, and 0 notice generate one dir-ideal-opamp.raw,it contains two files freqResp.ac and logFile open results browser, select freqResp.ac, I can not see the waveform in the waveform windows. why? |
Title: Re: [question] Spectre simulation Post by August West on Mar 9th, 2004, 3:14pm From within the results browser, once you navigate to the results directory, you must middle click on the mouse and select "Create ROF". This creates the "Run Object File" from the logFile, which describes the results to the results browser. Without it, the results browser does not treat the .ac file as a results file. -August |
Title: Re: [question] Spectre simulation Post by sim on Mar 9th, 2004, 8:22pm thanks for your reply! |
Title: Re: [question] Spectre simulation Post by Andrew Beckett on Mar 10th, 2004, 2:04pm If you're using IC50 or later, you might also want to consider using the new waveform tool "wavescan". It doesn't (yet) support all analyses, but will read dc, ac, and transient analyses right now - other analyses (such as RF analyses) coming soon. Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |