The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> spectre simulation speed from command https://designers-guide.org/forum/YaBB.pl?num=1078963277 Message started by jimmy on Mar 10th, 2004, 4:01pm |
Title: spectre simulation speed from command Post by jimmy on Mar 10th, 2004, 4:01pm Hi all, Does of any see a noticeable speed improvement in running spectre simulation from command line. I don't see much difference between running in command line and running in ADE. If you see a lot of difference, can you kindly let me know how to get the improvement? Thanks a lot, jimmy li |
Title: Re: spectre simulation speed from command Post by Andrew Beckett on Mar 10th, 2004, 10:55pm Jimmy, Why would you expect to see a speedup? It's the same simulator, so unless the fact you're running out of memory by having DFII/ADE running at the same time, or you are doing something else compute intensive in ADE, I'd not expect it to be any slower, really. (unless you're talking about the "spectreS" interface, because that could slow things down a lot because it was spending so much time printing information into the CIW and the top of the ADE window and the schematic window). With the "spectre" interface, there's minimal overhead in running via ADE. Andrew. |
Title: Re: spectre simulation speed from command Post by jimmy on Mar 11th, 2004, 10:46am Thank you, Andrew jimmy |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |