The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Modeling >> Passive Devices >> How to model flux MiM cap https://designers-guide.org/forum/YaBB.pl?num=1080741999 Message started by Roger on Mar 31st, 2004, 6:06am |
Title: How to model flux MiM cap Post by Roger on Mar 31st, 2004, 6:06am Hi all, 1.)How to model flux MiM in CMOS process for RF IC design ? 2.)Is there any concern to use flux MiM for RF IC? I have 5~6 metal layers. Thank you. Regards, Roger ??? |
Title: Re: How to model flux MiM cap Post by ghsee on Dec 19th, 2004, 4:49pm Hi Roger, I guess by now you should have done it. Anyway, just to share some of my experienced: 1.)How to model flux MiM in CMOS process for RF IC design ? I used standard pi model, the series branch are a cap,resistor and a inductor in series. 2.)Is there any concern to use flux MiM for RF IC? Probably only applicable for very small cap value . Others might have better explanation. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |