The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> PSS and PAC analysis for Mixer
https://designers-guide.org/forum/YaBB.pl?num=1085108307

Message started by mreja on May 20^th, 2004, 7:58pm

Title: PSS and PAC analysis for Mixer
Post by mreja on May 20^th, 2004, 7:58pm

May 20, 2004

Hello Everyone,

I have some confusions to set up PSS ans PAC anylysis for determining IIP3 for mixer. Could someone please help me how to set up PAC anylysis for mixer exactly?

For example, my RF frequency 1.9GHz and LO frequency 1.8GHz for downconversion mixer. What will be probable following setups in the PAC analysis window (ref. "Affirm Simulator (spectreRF) user Guide).

1. Sweep type= ....?
2. Single point frequency= ?
3. Sidebands ? if it is "Array of Indices" Then
Additional Indices= ......?
Please mention the numeric values.

I edited the RF port and did set up PSS anallysis according to the instructions mentioned in the "Affirm Simulator (SpectreRF) user Guide.

All Solutions and help will be greatly appreciated.

Thanks

Reja