The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> Phase Noise and Jitter Measurements >> How to get a clean clock source for PLL test?
https://designers-guide.org/forum/YaBB.pl?num=1088736932

Message started by ywguo on Jul 1st, 2004, 7:55pm

Title: How to get a clean clock source for PLL test?
Post by ywguo on Jul 1st, 2004, 7:55pm

Hello,

I am testing a PLL used as frequency synthesizer. It is convenient to use a HP pulse genrator as clock source because I can tune its output easily. But it has very large jitter. Its std deviation is ~200ps, pk-pk jitter is 800ps. Obviously it is too large. Should I use a crystal oscillator?  :-[  Or do you know any pulse generator that has a very clean output?

Thanks

Yawei

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.