The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Inverter Design with TSMC cmos18 techlib https://designers-guide.org/forum/YaBB.pl?num=1091651603 Message started by Fei on Aug 4th, 2004, 1:33pm |
Title: Inverter Design with TSMC cmos18 techlib Post by Fei on Aug 4th, 2004, 1:33pm Hi, I tried to simulate an inverter which is design with tsmc coms0.18 technology. The input is voltage pulse source. The simulator I chose was spectre. The results look strange (the output is high all the time no matter what the input voltage is?) I am wondering if I should choose any other simulator insteasd of spectre? Thanks Fei |
Title: Re: Inverter Design with TSMC cmos18 techlib Post by Andrew Beckett on Aug 4th, 2004, 3:18pm Did you remember to wire the power and ground up properly? Just changing the simulator is unlikely to help - it may possibly be a design kit/model problem, but much more likely is a circuit configuration problem, in which case you'll have trouble no matter what the simulator you use. Andrew. |
Title: Re: Inverter Design with TSMC cmos18 techlib Post by ywguo on Sep 3rd, 2004, 4:27am I guess that is an error in your netlist. :) You should check the netlist first when an error comes up. I think more than 90% curious phenomenan occuring in simulation is due to wrong design. :) Yawei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |