The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> Cadence inductor layout and extract view
https://designers-guide.org/forum/YaBB.pl?num=1114456533

Message started by Elinor on Apr 25^th, 2005, 12:15pm

Title: Cadence inductor layout and extract view
Post by Elinor on Apr 25^th, 2005, 12:15pm

Hi,

I am using cadence to make the RF design layut and I want to layout the inductor.
I know that the inductor is drawn with square or spiral layer of metal, but when I make the design rule check, there is an error message like label/pin is on net with different name and I failed to generate the extracted view. Could anyone give me a tutorial for this subject.
Thanks a lot.

Elinor

Title: Re: Cadence inductor layout and extract view
Post by vikas on May 10^th, 2005, 11:53am

Hello,

I remember that I too had some problem doing DRC check of inductor in cadence with Calibre DRC deck. There we removed dummy layer and got the drc working.

On the other hand with Diva drc deck i never had this kind of problem, and in all probability i guess u r using the same(Diva deck). So, if you could post a detailed error message then i might be able to help.

--Vikas