The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> Qn on OTA Simulation
https://designers-guide.org/forum/YaBB.pl?num=1122999088

Message started by Raj on Aug 2^nd, 2005, 9:11am

Title: Qn on OTA Simulation
Post by Raj on Aug 2^nd, 2005, 9:11am

Hi,
I had designed a Fully DIfferential Folded Cascode OTA. Now I want to characterize this OTA for CMRR,PSRR,SFDR,IMD,Slew Rate etc. The measurement setup for some of the above parameters need OTA to be configured in Unity Feedback. Now the question is

1. Can I have equal valued RESISTORS in input and feedback side of OTA which has 1pF load at both outputs?

2. If reistors are not allowed for OTA and should capacitive feedback alone be used to construct unity feedback for OTA, Please tell me the way of setting the DC bias for this.

3. For CMRR and PSRR measurements, is it needed to introduce mismatch in differential pair?

4. Can anyone tell me the way to simulate SFDR for an OTA.

Thanks Forum,
Raj.