The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> Drawing cross coupled pair
https://designers-guide.org/forum/YaBB.pl?num=1129104322

Message started by Derek on Oct 12^th, 2005, 1:04am

Title: Drawing cross coupled pair
Post by Derek on Oct 12^th, 2005, 1:04am

Hi All

I drawing some cross coupled mosfets using cadence schematic composer. Looking at some schematics drawn before, the wires could be drawn at diagonal degrees. I tried toggling with the options, but all my wires are still in orthogonal mode. Know that this is no of grave importance, just curious.Does anyone know where to tweak to draw wire diagonally? Thanks.

Title: Re: Drawing cross coupled pair
Post by sheldon on Oct 12^th, 2005, 1:35am

Derek,

Did you try the F3 key while routing a wire? The default for Draw Mode
is route, try setting it to the diagonal option.

Best Regards,

Sheldon

Title: Re: Drawing cross coupled pair
Post by Derek on Oct 12^th, 2005, 7:34pm

Hi Sheldon

Thanks.. yr suggestion works like a charm.

Regards