The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Behavioral Models >> SST Analysis
https://designers-guide.org/forum/YaBB.pl?num=1142982817

Message started by ASTRIX on Mar 21^st, 2006, 3:13pm

Title: SST Analysis
Post by ASTRIX on Mar 21^st, 2006, 3:13pm

AA

I am modelling an rf reciever, when modelling the noise I faced a proplem which is that when modelling mixer's noise an SST analysis should be used, But when modelling the LPF, which contains Laplace transform, there is some conflict between the SSt and the 'LTF, and the output is strange.
I wonder if there is a solution for this problem.

Yours
Shady Ragab

Title: Re: SST Analysis
Post by Eugene on Mar 22^nd, 2006, 10:45am

What does SST stand for?

What does LTF stand for?