The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> Output in ASCII format
https://designers-guide.org/forum/YaBB.pl?num=1150721223

Message started by aamar on Jun 19^th, 2006, 5:47am

Title: Output in ASCII format
Post by aamar on Jun 19^th, 2006, 5:47am

Dear All,

I am trying to extract the simulation outputs in ascii format, in the spectre documentation it is stated that I can use the -format psfascii option, but where can I set this option in the GUI of the Virtuoso?

Thanks,

aamar

Title: Re: Output in ASCII format
Post by Andrew Beckett on Jul 24^th, 2006, 2:00pm

There is no GUI setting to control the output format. This is because the tools need to be able to read the results...

You can probably specify "-f psfascii" in the userCmdLineOption field in the Setup->Environment form (I've not checked whether this works - it may not). You may also be able to specify the .cdsenv setting:

Code:

spectre.envOpts simOutputFormat string "psfascii"

but again, I've not checked that.

Andrew.