The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> AMS Simulators >> simulation AC in AMS environment
https://designers-guide.org/forum/YaBB.pl?num=1162312637

Message started by Pavel on Oct 31^st, 2006, 8:37am

Title: simulation AC in AMS environment
Post by Pavel on Oct 31^st, 2006, 8:37am

Hello

I have a filter described in Verilog-A.
How can I simulate it in AC.

Should I
- create symbol of this filter
- do shematic with it and some source
- call Analog Design Environment

or there is more simple way to proceed?

Thanks in advance.

Pavel.

Title: Re: simulation AC in AMS environment
Post by ACWWong on Nov 1^st, 2006, 7:02am

what you suggest is what i would do to setup an ac simulation of your verilogA code.

Title: Re: simulation AC in AMS environment
Post by Geoffrey_Coram on Nov 2^nd, 2006, 4:54am

I'd just write a spectre netlist by hand and run spectre from the command line ...