The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> High-Power Design >> question on error amp of a current mode converter https://designers-guide.org/forum/YaBB.pl?num=1162904536 Message started by glacieryy on Nov 7th, 2006, 5:02am |
Title: question on error amp of a current mode converter Post by glacieryy on Nov 7th, 2006, 5:02am Hi,all In a current mode dc-dc converter,the output of error_amp always connects with a compensation network to stablize the whole system and filter out the ripple at switching frequent. My problem is if I want to simulate the error_amp,should I connect the compension network or not ? Thanks in advance. Regards. Glacier |
Title: Re: question on error amp of a current mode conver Post by darrenxyz on Nov 28th, 2006, 7:22pm glacieryy wrote on Nov 7th, 2006, 5:02am:
|
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |