The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> what do i need for auto-routing of analog circuit
https://designers-guide.org/forum/YaBB.pl?num=1186713162

Message started by dpx4086 on Aug 9^th, 2007, 7:32pm

Title: what do i need for auto-routing of analog circuit
Post by dpx4086 on Aug 9^th, 2007, 7:32pm

what do i need for auto-routing of analog circuit ???

are ic5141, icc11241 and pdk enough ???
if not , what else do i need ???

thank you !

Title: Re: what do i need for auto-routing of analog circ
Post by skas20 on Aug 11^th, 2007, 1:33am

Other than what you mentioned,

1. Design netlist
2. technology files for these tools and licenses
3. PDK and verification rule decks if you need to verify the design.

- SK.

Title: Re: what do i need for auto-routing of analog circ
Post by dpx4086 on Aug 11^th, 2007, 7:40pm

skas20 wrote on Aug 11^th, 2007, 1:33am:

Other than what you mentioned,

1. Design netlist
2. technology files for these tools and licenses
3. PDK and verification rule decks if you need to verify the design.

- SK.

thank you SK.
what do u mean by "Design netlist"???

Title: Re: what do i need for auto-routing of analog circ
Post by haikom on Aug 16^th, 2007, 4:30am

Hi,

skas20 meant that you will need a schematic. If you use the Cadence tools, you can invoke the auto-router (icc) directly from the Virtuoso Schematic Editor. But as skas20 said, the pdk has to support icc.

Regards,
haiko