The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> stb analysis with mutiple loops
https://designers-guide.org/forum/YaBB.pl?num=1201763532

Message started by parth_sv on Jan 30^th, 2008, 11:12pm

Title: stb analysis with mutiple loops
Post by parth_sv on Jan 30^th, 2008, 11:12pm

Hello All,
I am trying to STB analysis in a multi-loop system. Iprobe is in feedback path there are actually two loops seen. Will stb analysis take care of both these loops?

Thanks in Advance,
Partha

Title: Re: stb analysis with mutiple loops
Post by Frank Wiedmann on Jan 31^st, 2008, 12:13am

Stb analysis can only be used for multi-loop circuits if there is a critical wire in the circuit that breaks all loops and if you place the stb probe in this wire. Please see the section titled "Applicability of Loop-Based and Device-Based Algorithms" in http://www.kenkundert.com/docs/cd2001-01.pdf for details. You might also be interested in the recent discussion at http://www.designers-guide.org/Forum/YaBB.pl?num=1198131494;start=all.