The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> Other Measurements >> Static parameter Measurement ADC
https://designers-guide.org/forum/YaBB.pl?num=1216649170

Message started by dinac on Jul 21^st, 2008, 7:06am

Title: Static parameter Measurement ADC
Post by dinac on Jul 21^st, 2008, 7:06am

Hi all,

I am new to designing and testing ADCs.
I have desigined a slow 5Bit ADC, which is similar to a sucessive approximation type. i am in btw my master thesis.

Now I would like to test for static parameters like gain , offset, INL and DNL.

It would be great, if any one could guide me in this, or direct me to a topic or reference.

Thanks a lot...

dinac

*********************
i hve extracted the values of the bits and vin to matlab and got a nice step, i did a sweep on vin for 1500 steps.