The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> Problem in RF IC Package Modeler Form
https://designers-guide.org/forum/YaBB.pl?num=1217501111

Message started by AnalogAroma on Jul 31^st, 2008, 3:45am

Title: Problem in RF IC Package Modeler Form
Post by AnalogAroma on Jul 31^st, 2008, 3:45am

Hi Everybody,

I need to draw the bond plan showing the connections beetween the IC package pins and chip-bondpads. So, I am using RF IC Package Modeler (PKG ).

While using this tool , I have noticed that the upper four side buttons are active in the opening form. But , the lower four buttons including " Internal lead frame setup " and "Macromodel Generation " remain inactive always. Even though, I have given inputs for the upper four features, the lower four buttons still remain disabled.

Is there any way to activate those lower four buttons ? Any workaround ?

With Regards,

IKB

Title: Re: Problem in RF IC Package Modeler Form
Post by Andrew Beckett on Jan 3^rd, 2009, 3:36pm

That doesn't happen for me. Perhaps it's a peculiarity of the options you've chosen for the earlier steps in the flow.

However I should point out that PKG has been end-of-lifed for some considerable time, and no work has been done on it for several years.

Regards,

Andrew.