The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> Annotating DC operating points
https://designers-guide.org/forum/YaBB.pl?num=1236959040

Message started by aamar on Mar 13^th, 2009, 8:43am

Title: Annotating DC operating points
Post by aamar on Mar 13^th, 2009, 8:43am

Hallo,

Is it possible to edit the DC Operating point parameters shown for a transistor using the Annotate DC Operating point? Earlier I was able to see the Vgs and Vds of MOSFETS on the schematic, after a software update, I see now the gm, vdsat and others but no voltages.

The other problem is that if I Annotate the DC node voltages, the voltage of internal nodes of blocks are not shown. The only possible way is to use the results browser to check the node voltages which is not the easy way in my opinion. Is it possible to show the voltages of the internal nodes?

Thanks,

aamar

Title: Re: Annotating DC operating points
Post by pancho_hideboo on Mar 13^th, 2009, 9:17am

You have to show tool's name you use regarding simulator and design environment(entry tool, framework).

Title: Re: Annotating DC operating points
Post by aamar on Mar 13^th, 2009, 9:24am

I am using cadence, the Virtuoso Schematic Editor. And the simulator is MMSIM7.0.

is that what you asked about?

thanks,

aamar

Title: Re: Annotating DC operating points
Post by pancho_hideboo on Mar 13^th, 2009, 9:33am

aamar wrote on Mar 13^th, 2009, 9:24am:

I am using cadence, the Virtuoso Schematic Editor. And the simulator is MMSIM7.0.
is that what you asked about?

Yes.
Use "Edit>Label Display" in menu of Schematic Window.