The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> RF Measurements >> Spectrum Analyzer settings https://designers-guide.org/forum/YaBB.pl?num=1251812733 Message started by salty on Sep 1st, 2009, 6:45am |
Title: Spectrum Analyzer settings Post by salty on Sep 1st, 2009, 6:45am Looking for advice/confirmation. I'm using an Agilent E4405B SA and I'm looking at phase noise/spurs of a pll. There are 4 detectors I can choose from peak, sample, neg peak, avg. Does this seem reasonable: 1> For Spurs use Positive peak since I'm looking for the max spur level 2> For phase noise, use the avg (It does an rms avg) 3> For sample, it is recommended for noise but does it do ok for phase noise? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |