The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Optimizing on both S-parameters and Harmonic Balance in ADS at the same time https://designers-guide.org/forum/YaBB.pl?num=1253264225 Message started by drgz on Sep 18th, 2009, 1:57am |
Title: Optimizing on both S-parameters and Harmonic Balance in ADS at the same time Post by drgz on Sep 18th, 2009, 1:57am As the subject title says, does anybody know how I do this? I'm designing an amplifier for a project at the university, and I want to try to optimize the design I already got a bit more. At the moment a harmonic balance simulation gives me a PAE of about 64% at the 1dB compression point, while the load-pull simulator tells me that I might achieve 73% PAE if I change my load to the "optimal" one. I know that higher PAE usually means loss of gain, but since I got a few dB to go on with respect to the specifications, I thought I might try to squeeze out a few more %. Now the thing is that this specific load for optimum PAE doesn't make the design fulfill the other specs like i.e. gain, return loss at in- and output, etc, but I still believe that it's possible to increase the PAE and still fulfill the other specs. So, I'm wondering if it's possible to simulate on both s-parameters and a harmonic balance at the same time, such that I can specify goals for S21dB, S11dB, S22dB, and at the same time set a goal for PAE at the 1dB compression point? |
Title: Re: Optimizing on both S-parameters and Harmonic Balance in ADS at the same time Post by drgz on Sep 19th, 2009, 9:32am Figured it out, a LSSP simulation was what I needed. :) |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |