The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> System Simulators >> Simulink Scope Viewer Blanks at Simulation End
https://designers-guide.org/forum/YaBB.pl?num=1310428327

Message started by loose-electron on Jul 11^th, 2011, 4:52pm

Title: Simulink Scope Viewer Blanks at Simulation End
Post by loose-electron on Jul 11^th, 2011, 4:52pm

Using Matlab Simulink version R2011A, Version 7.7, March 9, 2011 version of SW.

I can set up and run a Simulink solution, however, when the simulation run hits the end time, the Floating Scope display blanks out.

You see the traces display, and then at simulation end, the scope viewer screen goes blank except for a small snip at the end of the simulation.

Probably something very basic, and stupid.

Any ideas? Thanks!

Title: Re: Simulink Scope Viewer Blanks at Simulation End
Post by loose-electron on Jul 12^th, 2011, 12:51pm

Floating scope does not retain data, the regular scope function does.

Problem solved