The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to attach schematics to a new design kit in cadence ? https://designers-guide.org/forum/YaBB.pl?num=1313580986 Message started by The Falcon on Aug 17th, 2011, 4:36am |
Title: how to attach schematics to a new design kit in cadence ? Post by The Falcon on Aug 17th, 2011, 4:36am Hi How to migrate your cadence designs (schematics, library) to new technology design kit in cadence? Thanks |
Title: Re: how to attach schematics to a new design kit in cadence ? Post by Geoffrey_Coram on Aug 17th, 2011, 5:55am I think I saw a presentation at DAC a few years ago, in which Cadence was promoting an optimization-based tool that would help with migration. |
Title: Re: how to attach schematics to a new design kit in cadence ? Post by The Falcon on Aug 20th, 2011, 7:42am Thanks Geoffrey_Coram but, i'm asking about how to reuse the schematics for another design kit |
Title: Re: how to attach schematics to a new design kit in cadence ? Post by Geoffrey_Coram on Aug 22nd, 2011, 10:18am A new design kit for the same technology? Or a design kit for a new technology (smaller or different foundry)? |
Title: Re: how to attach schematics to a new design kit in cadence ? Post by The Falcon on Aug 23rd, 2011, 8:19am a new design kit of a smaller (different) technology but, i want to reuse my schematics Thanks |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |