The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Behavioral Models >> setting parameters in verilogams to vary with corners
https://designers-guide.org/forum/YaBB.pl?num=1360172395

Message started by sammy_bee on Feb 6^th, 2013, 9:39am

Title: setting parameters in verilogams to vary with corners
Post by sammy_bee on Feb 6^th, 2013, 9:39am

Hi All ,

I m new to verilogams. My verilogams module works fine with norminal model. Now i want to vary a parameter based on the digital corner being used my the simulator. For instance if the simulator is using strong models , I want to set parameter P = 1 and if it is using weak models , set P =2 .Can any of you provide me with help on how to do this?

Title: Re: setting parameters in verilogams to vary with corners
Post by spinfab on May 16^th, 2013, 4:50am

Hello,

The best way to do so, is to use a model card approach, i.e writing spectre netlist with 'model' statment.

fab