The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Other CAD Tools >> Physical Verification, Extraction and Analysis >> QRC's av_extracted view is not showing any metal layers https://designers-guide.org/forum/YaBB.pl?num=1362752875 Message started by VINAY RAO on Mar 8th, 2013, 6:27am |
Title: QRC's av_extracted view is not showing any metal layers Post by VINAY RAO on Mar 8th, 2013, 6:27am Hello all, I designed simple inverter using UMC65ll kit and it passed successfully in DRC, LVS, and QRC. But extracted view of this design isn't showing any metal layer instead schematic of transistor is shown (figure attached). I have also ran QRC by setting valid layers (LSW->edit->set valid layers->set all valid) but problem still remains the same. Moreover, I am only using METAL1, DIFFUSION and POLY1 layers. Versions are as follows. IC 614-06.14-512 Assura 4.1 USR2 with EXT101 & MMSIM 0720.593 How can I set up this to show layers in av_extracted view? Regards, Vinay Rao. |
Title: Re: QRC's av_extracted view is not showing any metal layers Post by bernd on Mar 12th, 2013, 1:25am This has been answered here (cross posting) http://www.cadence.com/Community/forums/p/25556/1321304.aspx#1321304 * |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |