The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> Help need for proper generation of layout in Agilent ADS.
https://designers-guide.org/forum/YaBB.pl?num=1378218423

Message started by sureshctaece on Sep 3^rd, 2013, 7:26am

Title: Help need for proper generation of layout in Agilent ADS.
Post by sureshctaece on Sep 3^rd, 2013, 7:26am

Dear Sir,

I have ATF 54143 4 -pin transistor , connected at the diagonally opposite two sources to resistor and ground. When I generated the layout for the this file diagonally opposite two sources. In the layout ,they are not appearing diagonally opposite, they are appearing side by side or adjacent to each other. How to get the two sources in the layout generation diagonally opposite to each other. I have shown below images of Schematic_ATF54143 and Generated_Layout_ATF 54143. Can you help me anybody.