The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> how to write .do file for batch simulation in ADVance MS https://designers-guide.org/forum/YaBB.pl?num=1381397568 Message started by Milind Shende on Oct 10th, 2013, 2:32am |
Title: how to write .do file for batch simulation in ADVance MS Post by Milind Shende on Oct 10th, 2013, 2:32am Hello All, I am using MentorGraphics ADVance MS simulator for my VHDL-AMS code simulation. In the simulator, there are two simulation options: Batch simulation or Interactive simulation. Interactive simulation is quite easy. and I normally use it. For some C++ programming task, I want to run ADVance MS simulator in batch mode. my problem is how can i write a .do file for batch simulation ? ref: I am using the batch simulation command from "Getting started with ADVanceMS" manual, page 5 command $ vasim -c -cmd [name of .cmd file] [entity_name] [architecture_name] -do [name of .do file] any guidelines to write .do file ? thanks in ADVance :) regards, Milind. |
Title: --- Post by Harry_108 on Jun 24th, 2015, 2:35am --- |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |