The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> RF Measurements >> Optical receiver Noise measurement https://designers-guide.org/forum/YaBB.pl?num=1391444171 Message started by raja.cedt on Feb 3rd, 2014, 8:16am |
Title: Optical receiver Noise measurement Post by raja.cedt on Feb 3rd, 2014, 8:16am dear All, I would like to know typical noise measurement of a optical receiver, my circuit consists of two single ended Trans impedance amplifiers and then these outputs are amplified with 3 stage differential amplifiers (around 70dB again total) . In my lab we are measuring single ended noise variance with real time scope and multiplying with sqrt(2) for the total differential noise(assuming both are UN-correlated), is this UN-correlated assumption valid in all cases or any exceptions? Thanks, Raj. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |