The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Behavioral Models >> Liberty Model
https://designers-guide.org/forum/YaBB.pl?num=1391591803

Message started by Battosai on Feb 5^th, 2014, 1:16am

Title: Liberty Model
Post by Battosai on Feb 5^th, 2014, 1:16am

Hello

I am currently composing a liberty timing file for an analog block to be used in a larger digital simulation. The pin description for most pins are only described by their direction, capacitance and rise_ -and fall_capacitance. What I can't figure out is how these latter values are defined? Should these values represent the equivalent capacitance that generates the same rise and fall times?