The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design Languages >> Verilog-AMS >> Bidirectional pin and discipline? https://designers-guide.org/forum/YaBB.pl?num=1391952472 Message started by Amblik on Feb 9th, 2014, 5:27am |
Title: Bidirectional pin and discipline? Post by Amblik on Feb 9th, 2014, 5:27am Hi Folks, i'm having some trouble with a bidirectional pin on my top level design. I have lots of bidirectional pins which are ok because they are logic. (I2C etc). However one pin in particular is a digital output in mission mode, but can be configured as an analogue input in test mode. I'm not sure how to set up the drive capability for this. I'm guessing i would need to declare the pin as analogue and perform all my driving/sensing in the analogue domain. Is there a "usual" way of doing this? I'd hate to go re inventing the wheel but searches aren't giving me much. Thanks for any info. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |