The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Physical Verification, Extraction and Analysis >> Cannot enable LVS push device.
https://designers-guide.org/forum/YaBB.pl?num=1395010917

Message started by Jacki on Mar 16^th, 2014, 4:01pm

Title: Cannot enable LVS push device.
Post by Jacki on Mar 16^th, 2014, 4:01pm

Hello,

I am trying to extract the parasitics by using calibre PEX. The calibre LVS check is good, but when I use PEX to extract the parasitics, I get a warning "NO LVS PUSH DEVICES", "Cannot enable LVS PUSH DEVICES because pin location information was requested".
First I don't understand what the "LVS PUSH DEVICES" are. Second I don't know how to enable it because I never face this problem for my previous experience with calibre. I want to claim that the LVS is clean, so I really do not understand the "pin location information was requested".
Any comments are welcome.
Thank you.

Title: Re: Cannot enable LVS push device.
Post by Jacki on Apr 2^nd, 2014, 1:50pm

I found it was possible to continue the extraction with this warning.