The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Physical Verification, Extraction and Analysis >> bondwire simulated with hfss
https://designers-guide.org/forum/YaBB.pl?num=1397285997

Message started by baohulu on Apr 11^th, 2014, 11:59pm

Title: bondwire simulated with hfss
Post by baohulu on Apr 11^th, 2014, 11:59pm

hi,all
I have setup a bondwire modeling with hfss, after hfss analysis, the results shows s parameter, y,z parameter, vswr....
however, it does't show the L and Q of the bondwire, then how can I know the two usually used values? calculate the L & Q with s parameter?? who knows the formula ?
or cadence can use the s parameter extracted from hfss?

besides the bondwire, I saw a document modeling a symmetric spiral with hfss, after the analysis, it uses the following formula to calculate the spiral , but it does't show its equivalent circuit .
so , the following zp1, zp2, Rs.... I can't know what it represents.