The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Physical Verification, Extraction and Analysis >> Writing to .csv while doing corner in ADEXL using OCEAN.
https://designers-guide.org/forum/YaBB.pl?num=1399349518

Message started by VINAY RAO on May 5^th, 2014, 9:11pm

Title: Writing to .csv while doing corner in ADEXL using OCEAN.
Post by VINAY RAO on May 5^th, 2014, 9:11pm

Hello all,

I am doing corner analysis for my LNA and I have got around 15 corners. So I want to record each response in .csv file. I selected only few corners and saved OCEAN from ADEXL and it has got following command for corner as follows.

ocnxlCorner( "C0"
("model" "/home/vinay_rao/library/Models/Spectre/L65LL_RVT12_V101_RF.lib.scs" ?section "\"tt\" \"ff\" \"fnsp\" \"snfp\" \"ss\"")
) )

My question is “Are there any options in OCEAN which can track each corner's response and then automatically save it to .csv”? I am trying to avoid FOR loop kind because it becomes very messy if I have to include all the corners. I am new to OCEAN, so any kind of suggestion would be appreciable. Thank you.

Regards,
Vinay Rao.