The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to selectively run monte carlo on a subcircuit block in Hspice
https://designers-guide.org/forum/YaBB.pl?num=1406859531

Message started by blam on Jul 31^st, 2014, 7:18pm

Title: how to selectively run monte carlo on a subcircuit block in Hspice
Post by blam on Jul 31^st, 2014, 7:18pm

For a large circuit consisting of several subcircuits, if I want to see which subcircuit is most sensitive to process variation, which means variation of the subcircuit has the most contrition to the overall variation on top level, is there a way to run hspice on the top level and monte carlo for a single subcircuit at the same time? This way I think I can break down the contribution from each subcircuit.

Thanks!