The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Transmission Lines and Other Distributed Devices >> impedance matching using Stripline
https://designers-guide.org/forum/YaBB.pl?num=1406881173

Message started by Ritesh on Aug 1^st, 2014, 1:19am

Title: impedance matching using Stripline
Post by Ritesh on Aug 1^st, 2014, 1:19am

Hello,
I have a 54.5 ohm coax with
1.Delay - 3.3340 ps/mm (0.0847 ns/in)
2.Inductance per mm - 0.1751 nH/mm (4.45 nH/in)
3.Capacitance per mm - 0.6338 pF/mm (1.61 pF/in)

How can I match with stripline with all details like length,width,height
dielectric is 4.2.
Iam concerned about the length. How long the stripline should be.
Should i make a straight stripline or with turns.