The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design Languages >> VHDL-AMS >> Modelling of Vibratory Gyroscope using VHDL-AMS
https://designers-guide.org/forum/YaBB.pl?num=1435138061

Message started by Harry_108 on Jun 24^th, 2015, 2:27am

Title: Modelling of Vibratory Gyroscope using VHDL-AMS
Post by Harry_108 on Jun 24^th, 2015, 2:27am

Hi,

I need little conceptual help on 2DOF vibratory gyroscope (please check the attached file).

I am modelling Mass spring damper system using VHDL-AMS.

in the design I have two mechanical resonator

I have done following connections.

terminal t1: translational;

there are 2 springs, 2 dampers and 2 masses in the system
suffix 1 is used for drive and 2 is used for sense resonator

spring_1:
P end is connected to traslational_ref;
n end is connected to t1;

Damper_1:
P end is connected to traslational_ref;
n end is connected to t1;

Mass_1: (has only one end)
p end is connected to t1;

now my question is how to connect spring_2, Damper_2 and Mass_2 ???

appreciate your earlier replies.

thanks,

Harry_108