The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Behavioral Models >> dynamic Pulse Train
https://designers-guide.org/forum/YaBB.pl?num=1435198945

Message started by Joe Shmoe on Jun 24^th, 2015, 7:22pm

Title: dynamic Pulse Train
Post by Joe Shmoe on Jun 24^th, 2015, 7:22pm

Hi,

I searching for a possibility to apply a dynamic pulse train.
For example:
Vread_Vset_Vread_Vset_.... (Vset increases incrementally)
if a specific current is detected during Vread then I would like to apply another pulse train:
Vread_Vreset_Vread_Vreset_....(Vreset increases incrementally)

What is the best way to implement such a model card?

Thanks,
Joe

Title: Re: dynamic Pulse Train
Post by sheldon on Jun 25^th, 2015, 10:51pm

Why don't you try doing this with Verilog A? It is good for
one off test equipment like this.

Sheldon

Title: Re: dynamic Pulse Train
Post by Joe Shmoe on Jun 26^th, 2015, 9:15am

Hi Sheldon,

thanks your reply!

Since my subcircuit is written in Verilog-A this is a good option.

Now, how would I do that? Could you give me a hint how to start?

Thanks,
Joe

Title: Re: dynamic Pulse Train
Post by sheldon on Jun 26^th, 2015, 5:25pm

Voltages are pretty straightforward. How about creating a
branch and monitoring the current in the branch?