The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Why I get different results ? https://designers-guide.org/forum/YaBB.pl?num=1441282165 Message started by alexis57 on Sep 3rd, 2015, 5:09am |
Title: Why I get different results ? Post by alexis57 on Sep 3rd, 2015, 5:09am Hello everyone, I'm trying to simulate an ADC with Cadence and spectre ADE-L. I simulate my circuit during 10uS and the maximum clock frequency is 128MHz. I run many times but I get each times a different result. I'm blocked. I looked at the netlist files, they are same everytime. I don't change anything, just show the result, save, run again, save the new result and compare the files. Different... What can I should look at ? For "Simulation Performance Mode" I selected APS and "Use ++aps", it could be the cause ? I will try to launch many times by selecting "spectre" but it's becoming really slow now... Thank you very much. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |