The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> PNOISE sim of switched capacitor S/H circuit in "source" mode
https://designers-guide.org/forum/YaBB.pl?num=1442681168

Message started by neoflash on Sep 19^th, 2015, 9:46am

Title: PNOISE sim of switched capacitor S/H circuit in "source" mode
Post by neoflash on Sep 19^th, 2015, 9:46am

I am simulating a 2-phase (sample and hold) switched capacitor circuit used in pipelined ADC front end.

I have seen method of using timedomain mode in pnoise and calculate the noise in sample phase and hold phase separately.

I have also set it up in source mode and observe the total noise at output. I am curious that what is the noise result I get from this simulation and how is it comparing to the result in timedomain method?