The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> Other Measurements >> WaveView width measurement of a pulse
https://designers-guide.org/forum/YaBB.pl?num=1447777955

Message started by rioni on Nov 17^th, 2015, 8:32am

Title: WaveView width measurement of a pulse
Post by rioni on Nov 17^th, 2015, 8:32am

Hello,

I am using WaveView to measure the output width of a pulse.

My problem is that when I use the measurement tool and choose the Meter Y Level to be locked at 50% , the result width is not in the 50 % of Y Level (I attached a printscreen of it).

My question is should I uncheck the 50% option and move the Meter by hand in the middle of the height of the pulse?

Thank you.

Title: Re: WaveView width measurement of a pulse
Post by rioni on Nov 17^th, 2015, 8:36am

To make it clearer , what I suggest to do by hand is the printscreen bellow .