The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> iip3 https://designers-guide.org/forum/YaBB.pl?num=1459261307 Message started by dg12 on Mar 29th, 2016, 7:21am |
Title: iip3 Post by dg12 on Mar 29th, 2016, 7:21am Hello I need some help regarding the measurement of iip3 for transconductor or an inverter. If I want to use this transconductor in filters what load should I connect at the output to measure the iip3?? If I need a port at the output how can the resistance value be decided?? Regards Dg |
Title: Re: iip3 Post by Ken Kundert on Mar 30th, 2016, 12:35am You should load your circuit based on what it will be driving. You need not use a port. -Ken |
Title: Re: iip3 Post by dg12 on Mar 30th, 2016, 3:43am Thanks for the reply... If I'm using a capacitive load, can you elaborate on how to measure iip3 without using port?? |
Title: Re: iip3 Post by Ken Kundert on Mar 30th, 2016, 4:04pm I'm afraid I don't have the time. Why don't you just try it. You can report back if you get stuck. -Ken |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |