The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Issue with Expression plot in ADE calculator
https://designers-guide.org/forum/YaBB.pl?num=1472716104

Message started by AMS_ei on Sep 1^st, 2016, 12:48am

Title: Issue with Expression plot in ADE calculator
Post by AMS_ei on Sep 1^st, 2016, 12:48am

Hi,

I am trying to plot a digital signal using calculator after transient analysis.
I am able to get the faithful result at individual output.
However, while trying to calculate an expression (4 * VT("/oB<2>")), and simulate it, I am not getting the value 4. Instead I am getting 20V on Y-Axis, where oB<2> is declared as reg.
I've run a transient analysis in ADE with AMS (spectre solver).

Please see the waveform attached.

Could anyone please explain me how can I plot a digital signal in an expression as mentioned above in order to obtain a value of 4 on the Y-axis and X-axis is time as is.

Thank you.

Warm regards,

Title: Re: Issue with Expression plot in ADE calculator
Post by AMS_ei on Sep 1^st, 2016, 2:44am

I have fixed it