The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> Commonly used Amplifier Topologies for RF circuit for FM Band question
https://designers-guide.org/forum/YaBB.pl?num=1485466136

Message started by philm001 on Jan 26^th, 2017, 1:28pm

Title: Commonly used Amplifier Topologies for RF circuit for FM Band question
Post by philm001 on Jan 26^th, 2017, 1:28pm

Hello all,

I was wondering if I could get some help. I am looking into designing some RF circuits for a project and I was wondering if there are any commonly used topologies for amplifing the signal? I found this pdf which I have been using as a reference:
http://www.qsl.net/v/va3iul/RF%20Power%20Amplifiers/RF_Power_Amplifiers.pdf

But the document presents all of the topologies that are available. Which is fine but again, I am wondering if there are any that are used alot in RF FM design.

Also, for one of my projects, I will be using RDS to control a device. Again, I was wondering if there are any commonly used amplifiers for FM sideband (the sideband is what the RDS works in).