The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> SMA rigth angle end cap compression
https://designers-guide.org/forum/YaBB.pl?num=1505147190

Message started by rongard21 on Sep 11^th, 2017, 9:26am

Title: SMA rigth angle end cap compression
Post by rongard21 on Sep 11^th, 2017, 9:26am

Hello

Could somebody suggest or reference me to a tool which is meant for pressing in the end cap for right angle SMA plug. I'v searched the net pretty thoroughly, but it would seem that such a tool does not exist, but I'm pretty sure that not everybody installs the end cap like I do at the moment - with hammer and a large hex drive.