The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> mixed signal simulation of a transmitter running very slow https://designers-guide.org/forum/YaBB.pl?num=1522308852 Message started by nischaybm on Mar 29th, 2018, 12:34am |
Title: mixed signal simulation of a transmitter running very slow Post by nischaybm on Mar 29th, 2018, 12:34am HI, I am trying to run a transient simulation of a transmitter block. I have got all the biases up, but still i dont have the CLK enabled. once I enable the dividers (without CLK) the simulations start to slow down a lot. can anybody suggest me some settings in ADE/irun to report the oscillating nodes or nodes thats causing to slow the simulation ? Thanks, nischay |
Title: Re: mixed signal simulation of a transmitter running very slow Post by Ken Kundert on Mar 29th, 2018, 2:00pm You might want to take a look at the supply currents. That can often lead you to the activity. Alternatively, you can try setting 'diagnose=detailed' (transient options), but that can be difficult to parse. -Ken |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |